This article mainly introduces:

Egypt hydraulic cylinder,stacker cylinder manufacturer,stacker cylinder

(Egypt stacker cylinder,produced by Hengyu Group）

stacker cylinder are widely used in Egypt，because of clever hydraulic energy conversion，simple structure and reliable operation，excellent temperature resistance.So our company has designed stacker cylinder for customers from Egypt.

Introduction to stacker cylinder:

The stacker cylinder should be used as far as possible to avoid the transverse force, sometimes the piston rod to bear the transverse load is too large, especially do not force or pull the stacker cylinder, bite. Elimination method: When installing the stacker cylinder, ensure that the axis position of the stacker cylinder is consistent with the direction of movement; Make the load borne by the stacker cylinder as far as possible through the stacker cylinder axis, to avoid the phenomenon of eccentricity.

The pressure of the sliding surface of the stacker cylinder piston is too large, resulting in sintering. The piston tilts due to the weight of the piston rod, resulting in the phenomenon of non-stiffness, or the pressure of the sliding surface of the piston rises due to the action of the transverse load, which will cause sintering. In the design of the stacker cylinder must study its working conditions, the length of the piston and bushing and the size of the clearance must be fully paid attention to.

The stacker cylinder is a hydraulic actuator that converts hydraulic energy into mechanical energy and does linear reciprocating motion (or swinging motion). It is simple in structure and reliable in operation. When it is used to achieve reciprocating movement, the deceleration device can be eliminated, and there is no transmission gap, and the movement is smooth, so it is widely used in various mechanical hydraulic systems. The output force of the stacker cylinder is proportional to the effective area of the piston and the pressure difference between the two sides; The stacker cylinder is basically composed of stacker cylinder and stacker cylinder head, piston and piston rod, sealing device, buffer device and exhaust device. Buffer device and exhaust device depending on the specific application, other devices are essential.

Regular maintenance of the stacker cylinder includes: regular tightening, stacker cylinder fastening screws and gland screws, stacker cylinder piston rod stop adjustment screws, should be tightened once a month, tighten each screw evenly, and achieve the corresponding tightening torque. Replace the seal regularly, it is recommended to replace the seal of the stacker cylinder once a year. Clean regularly, the stacker cylinder is cleaned every other year, and the seals are replaced while cleaning.

Answers to some questions about stacker cylinder:

How to calculate the inner diameter of the hydraulic cylinder?
These two parameters need the following information to decide: 1, pump displacement, speed (to get the actual output flow of the pump) 2, three and time requirements (lift time, drop time takes a few seconds) and then view the close cylinder series according to the results. Select the right cylinder.

The two cylinders of the bending machine are out of sync?
Check whether the sliding slide is worn, adjust its tightness, so that both sides are consistent, check whether the two cylinder tubing is connected, tighten the flow valve, pressure, let the cylinder air discharge.