Release time:2023-11-24 16:13:22 Hits: Current position: Home > News
This article mainly introduces:
Japan hydraulic cylinder,self-locking hydraulic cylinder manufacturer,self-locking hydraulic cylinder(Japan self-locking hydraulic cylinder,produced by Hebei Hengyu company)
self-locking hydraulic cylinder are widely used in Japan,because of simple structure and reliable operation,excellent temperature resistance,no transmission clearance.So our company has designed self-locking hydraulic cylinder for customers from Japan.
The piston rod of the self-locking hydraulic cylinder has two kinds of solid rod and hollow rod, and one end of the hollow piston rod needs to be set aside for welding and heat treatment. The solid piston rod material is 35, 45 steel, and the hollow piston rod material is 35, 45 seamless steel pipe. After rough machining, the piston rod is conditioned to 229~285HB in India, and if necessary, the hardness is 45~55HRC after high-frequency quenching.
The definition of the minimum starting pressure of the self-locking hydraulic cylinder refers to the minimum working pressure of the self-locking hydraulic cylinder in the no-load state, which is a comprehensive index reflecting the manufacturing and assembly accuracy of the self-locking hydraulic cylinder parts and the size of the sealing friction.
The pressure, temperature, medium and speed of different types of seals are not the same, water-ethylene glycol medium (HFC) can not be sealed with polyurethane, it can only use rubber seal; When the self-locking hydraulic cylinder is running fast, it must be sealed with slip ring, such as Sterseal, Glairing, GD1000K, TDI, etc., when the running speed is slow, Yx, U, V combination seals can be used; Fluorine rubber seal is used in high temperature and high pressure environment; When the running speed is fast, the buffer sleeve and buffer valve must be considered.
If the piston rod and self-locking hydraulic cylinder are stuck or the self-locking hydraulic cylinder is blocked, at this time, no matter how to operate, the self-locking hydraulic cylinder does not move or has little action. At this time, check whether the piston and piston rod seal is too tight, whether it enters the dirt and gum deposits: whether the shaft line of the piston rod and the self-locking hydraulic cylinder is in the center, whether the wearing parts and seals are invalid, and whether the load is too large.
What steel pipe does hydraulic cylinder use? This problem is very general. Carbon steel pipe or ordinary seamless steel pipe are all ok, but then there are rolling, quilting, heat treatment and other steps, and the requirements are different, the wall thickness is different, the material is different. It depends on the circumstances.
What adhesive should be used when the cylinder is cracked?
There is a kind of cast iron glue, industrial products market can buy, A, B formula, that is, a tube is A, a tube is B, when used proportionally prepared, check the instructions. Polish the glue after it dries, and then grind it again.