This article mainly introduces:
Bahrain hydraulic cylinder,reset cylinder manufacturer,reset cylinder(Bahrain reset cylinder,produced by Hengyu Group)
reset cylinder are widely used in Bahrain,because of clever hydraulic energy conversion,simple structure and reliable operation,excellent temperature resistance.So our company has designed reset cylinder for customers from Bahrain.
Analysis of commonly used seals: The wear ring and slip ring commonly used on the reset cylinder are generally made of polytetrafluoroethylene + graphite, because pure polytetrafluoroethylene is easy to produce plastic creep, which is only suitable for low pressure and low wear resistance conditions. If the sealing ring used is a composite material formed after adding graphite filler, the performance can be effectively improved, the ability to resist plastic creep is increased by 2 to 3 times, the initial deformation caused by the load is reduced by 30 to 60% : the rigidity is increased by 2 to 3 times: the dimensional stability under heat is increased by 2 times, and the hardness is increased by l0 to 15%.
If the seal of the reset cylinder is softened and sticky, it may be that the seal is incompatible with the hydraulic oil or the nearby lubricating oil, replace the appropriate seal; If the seal becomes hard and loses elasticity, most of it is because the ambient temperature is too high (more than 80 ° C), make appropriate temperature insulation protection or replace the high temperature seal.
The internal leakage of the reset cylinder should be prevented when the reset cylinder is used. The internal leakage of reset cylinder includes the leakage caused by excessive wear of reset cylinder block seal, piston rod and seal cover seal and piston seal. The cause of sealing leakage between the piston rod and the seal cover is that the seal is wrinkled, squeezed, torn, worn, aging, deterioration, deformation, etc., and a new seal should be replaced at this time.
Piston reset cylinder is widely used in hydraulic transmission. When the reset cylinder works, it mainly delivers hydraulic oil alternately to both sides of the piston in the reset cylinder, and uses the pressure difference of hydraulic oil on both sides of the piston to realize the reciprocating movement of the piston. If you want to speed up the forward speed of the piston, the return oil in the reset cylinder can be controlled by the valve and directly input into the inlet pipe to participate in the work of the piston to achieve rapid movement of the piston, but the thrust of the piston is reduced much.
What diameter cylinder is needed for a force of 5 tons?
It depends on the pressure of your system pump. If the normal working pressure of the system is about 8MPa, then the diameter of the cylinder should be 100 mm.
What is the function of the forklift truck cylinder and how does it work?
(1) In order to quickly and conveniently pick up the goods, the gantry needs to be tilted forward; In order to prevent the goods from falling, the door frame should be tilted backward to ensure the stability of the goods. The front and back tilt of the frame is accomplished by tilting the oil cylinder. (2) The inclined cylinder is composed of a piston, a cylinder block, a piston rod, an upper cover, a lower cover, a compression nut and a cover female and other main parts. (3) The inclined cylinder has two oil holes that can be interchanged into oil inlet and discharge holes. The cylinder is divided into a front cavity and a back cavity by a piston. The back cavity is filled with high-pressure oil when it tilts forward, and the front cavity is filled with high-pressure oil when it tilts backward.