Release time:2023-11-12 15:27:58 Hits: Current position: Home > News
This article mainly introduces:
S.Africa hydraulic cylinder,sanitation truck hydraulic cylinder manufacturer,sanitation truck hydraulic cylinder(S.Africa sanitation truck hydraulic cylinder,produced by Hengyu Hydraulic Cylinder Factory)
sanitation truck hydraulic cylinder are widely used in S.Africa,because of excellent fatigue and impact resistance,no need for deceleration device,long service life.So our company has designed sanitation truck hydraulic cylinder for customers from S.Africa.
The machining accuracy of the sanitation truck hydraulic cylinder depends on the level of equipment, production technology and testing means. sanitation truck hydraulic cylinder processing methods are commonly used in two ways, one is rough boring - fine boring - rolling, generally with 45# seamless steel pipe, this method of processing quality is good, but the cost is high. Another method is to use 20# cold-drawn seamless steel pipe, and then honing, the cost is lower. The piston rod must be adjusted and straightened before processing, and the coating thickness of the piston rod is generally not less than 0.03mm. The piston must be machined in strict accordance with the groove size and tolerance requirements given in the seal manual.
The method of sleeve sanitation truck hydraulic cylinder to improve the processing quality: there is a big gap in the service life of post-plating polishing and post-plating polishing, especially in mass production. Strictly clean the flying edge and burr of mechanical components, especially the edge of the sealing groove, and the tiny metal burr, strictly clean before assembly. The surface fatigue strength and stress corrosion resistance of the sanitation truck hydraulic cylinder can be significantly improved by rolling in the finishing of the inner holes of the sanitation truck hydraulic cylinder. The roughness of the surface of the friction pair is generally controlled between Ra0.4 and 0.8.
Before the sanitation truck hydraulic cylinder is removed, the system should be unloaded, the loop pressure is zero, the oil source should be cut off, and the oil port should be blocked after the oil port distribution pipe is loosened.
The sanitation truck hydraulic cylinder should not be mixed with foreign objects during assembly, which will cause scars. Before the total assembly of the sanitation truck hydraulic cylinder, all parts must be fully removed and cleaned. When the parts are installed with burrs or dirt, foreign objects are easily embedded into the surface of the sanitation truck hydraulic cylinder wall due to the stiffness and the weight of the parts, causing scars.
Why is a light cylinder less productive than a heavy cylinder at the same oil pressure?
f=ps Under the same pressure, the larger the area, the greater the output, but the maximum pressure can not exceed the system engineering pressure of the cylinder!
CNC lathe rotary cylinder oil leakage and treatment methods
Oil leakage often occurs when the cylinder (especially the hollow cylinder) of the CNC lathe is installed. First check the cylinder yaw, be sure to reach or close to the required value, generally the cylinder requires the outer beat within 1 wire. Otherwise, too much beating is sure to leak oil. Then check whether the tubing is smoothly downward at a certain Angle, and can not bend. Look at the pipe outlet can not go into the oil level, to a little higher. Otherwise, there's back pressure and it's gonna leak.